Cleaning Steps Of Anti-vibration Bracket

1. The cleaning treatment should run through the entire pipeline system of the seismic support. After cleaning and connecting, the ends of each pipe section should be tightly sealed to prevent any dirt, water or other foreign substances from entering the pipe. The vertical pipe shall be supported by an approved steel pipe code in the middle of each vertical pipe to prevent shaking, sagging, vibration and common vibration, and to avoid pressure on the pipe caused by resistance or torsion between the seismic support or the fixed support.

2. Take all precautions to avoid foreign objects such as welding beads and welding slag or dirt from entering the pipeline system. Beat the finished weld to loosen the debris. All pipes, valves and fittings shall be cleaned with metal brushes and wipers between the assembly of the system to remove oil, grease or dirt in the pipe; 2. Take all precautions to prevent external objects (such as weld beads, slag or dirt) Enter the piping system. Beat the finished weld to loosen the debris. All pipes, valves and fittings should use metal brushes to remove oil, grease or dirt in the pipes, and wipe them between the components and the system; 3. After the pipes and standpipes are connected, all pipes with a diameter of 150 mm and below should be Then rinse with clean water until the dirt, oil and metal chips are completely removed. Under normal circumstances, each size of pipe should be rinsed separately before being connected to a larger size pipe;

3. After the seismic support pipeline is connected to the riser, all pipelines with a diameter of 150mm and below should be flushed with clean water until the dirt, oil and metal chips are completely removed. In general, each size of pipeline should be flushed separately before connecting to a larger pipeline;

4. Steel brushes should be used to clean the pipeline, pulling and scrubbing the entire length of each section of the pipe, and then wiping with a fiber brush or rag that is slightly larger than the inner diameter of the pipe;

5. Clean the pipeline with a steel brush, pull the brush over the entire length of each section of the pipeline, and then wipe it with a fiber brush or a rag slightly larger than the inner diameter of the pipeline;