Precautions For Installation Of FRP Bracket

1. The installation should be economical and reasonable, with the shortest distance and safe operation, but the most important thing is to meet the requirements of engineering construction, laying and maintenance.

2. After the cable is laid, the deflection of the trunking should not be greater than 1/200 of the supporting span. When the support span exceeds 6000mm, the deflection should not be greater than 1/150 of the support span.

3. Try to install on buildings and structures (such as walls, columns, beams, buildings, etc.).

4. When installing with the process tube rack, the bracket should be placed on the side of the tube rack.

5. The installation of the combined bracket requires that the groove wall must be smooth. Only when this requirement is met can it be installed. The installation method of the combined bracket is to assemble the combined bracket on the slot assembly according to user requirements (such as 4, 5, 6, 7 as a group). At the same time, in the process of installing the combined bracket, the installation distance must reach the standard. Such

6. Screw-type bracket installation_The screw-type bracket installation is relatively simple. Professionals only need to install and fix the telescopic screw in the hole at the position required by the cable groove installation engineering design.

7. The installation of integral brackets is somewhat similar to the installation of combined brackets. The difference is that the integral bracket eliminates the step of using the slot assembly to assemble the combined bracket into a whole. Only special expansion screws are needed to fix the bracket on the groove wall as required. Above, it should be noted that the overall bracket generally has two types of double and triple, which can usually be used in a cable laying environment that is not very dense.